Instructions For Periodic Maintenance; Service, Spare Parts And Guarantee - Dolmar RescueCut Instructions D'emploi

Instructions for periodic maintenance

To ensure long life, prevent damage and ensure the full functioning of the safety features the following maintenance must be performed
regularly. Guarantee claims can be recognized only if this work is performed regularly and properly. Failure to perform the prescribed
maintenance work can lead to accidents!
General
Before each start
Every day
Storage

Service, spare parts and guarantee

Maintenance and repair
Consult a service centre for all work not described in this instruction manual. The service centres have all the necessary equipment
and skilled and experienced personnel, who can work out cost-effective solutions and advise you in all matters.
Guarantee
We guarantee this product to be in good working order and will reimburse the purchaser for replacement of faulty parts in the event of
material or manufacturing defects that arise within the warranty period. Please note that in some countries particular guarantee conditions
may exist. If you have any questions, please contact your salesman, who is responsible for the guarantee of the product.
Please note that we cannot accept any responsibility for damage caused by:
• Disregard of the instruction manual.
• Non-performance of the required maintenance and cleaning.
• Normal wear and tear.
• Improper sharpening.
• Cutting with a dull chain.
• Obvious overloading due to permanent exceeding of the upper performance limits.
• The use of non-approved guide bars.
• Use of force, improper use, misuse or accidents.
• Work on the chain saw by unskilled persons or inappropriate repairs.
• Use of unsuitable spare parts or parts which are not original parts, insofar as they have caused the damage.
• Operation with no or unsuitable saw chain oil.
• Damage related to conditions arising from lease or rent contracts.
Cleaning, servicing and adjustment work is not covered by the guarantee. All repairs covered by the guarantee must be performed
by a service centre.
To Þ nd your local distributor, please visit www.dolmar.com
20
Saw chain
Guide bar
Saw chain
Guide bar
Saw chain
Guide bar
Guide bar support
Chain, guide bar
Sharpen regulary, replace in good time
Turn over to ensure even wear of bearing surfaces
Replace in good time
Inspect for damage and sharpness
Check chain tension
Check for damage
Check the tungsten inserts
Check for damage, clean oil intake bore
Clean, in particular the oil guide groove
Demount, clean and oil slightly
Clean the guide groove of the guide bar