Fuels / Refuelling; Putting Into Operation - Dolmar RescueCut Instructions D'emploi

Fuels / Refuelling

- Stop the engine before refuelling the chain saw.
- Do not smoke or work near open Þ res (5).
- Let the engine cool down before refuelling.
- Fuels can contain substances similar to solvents. Eyes and skin
should not come in contact with mineral oil products. Always wear
protective gloves when refuelling. Frequently clean and change
protective clothes. Do not breathe in fuel vapors. Inhalation of
fuel vapours can be hazardous to your health.
- Do not spill fuel or chain oil. When you have spilt fuel or oil im-
mediately clean the chain saw. Fuel should not come in contact
with clothes. If your clothes have come in contact with fuel,
change them ot once.
- Ensure that no fuel or chain oil oozes into the soil (environmental
protection). Use an appropriate base.
- Refuelling is not allowed in closed rooms. Fuel vapors will ac-
cumulate near the ß oor (explosion hazard).
- It is particularly dangerous to handle fuels at Þ re scenes and
near open ß ame.
- Ensure to Þ rmly tighten the screw caps of the fuel and oil
tanks.
- Change the place before starting the engine (at least 3 m from
the place of refuelling) (6).
- Fuel cannot be stored for an unlimited period of time. Buy only
as much as will be consumed in the near future.
- Use only approved and marked containers for the transport and
storage of fuel and chain oil. Ensure children have no access
to fuel or chain oil.

Putting into operation

- Do not work on your own. There must be someone around
in case of an emergency (within shouting distance).
- Ensure that there are no children or other people within the
working area. Pay attention to any animals in the working area,
as well (7). When cutting steel, alloys, glass or other non-wood
materials, other people and animals should be kept at least 15
meters (45 feet) away.
- Before starting work the chain saw must be checked for
perfect function and operating safety according to the pre-
scriptions.
Check especially the function of the chain brake, the correct
mounting of the guide bar, the correct tightening of the chain,
the Þ rm mounting of the sprocket guard, the easy motion of
the throttle lever and the function of the throttle lever lock, the
cleanliness and dryness of the handles, and the function of the
ON/OFF switch.
- Start the chain saw only after complete assembly and inspection.
Operation of the device is only permitted after all the appropriate
accessories are attached!
- Before starting the chain saw ensure that you have a safe
footing.
- Put the chain saw into operation only as described in this instruc-
tion manual (8). Other starting methods are not allowed.
5
6
7
3 meters
15