Honda MIIMO HRM40 Instructions Originales page 15

14 | English
Problem
Mower fails to
operate
Mower standing on
lawn with the display
switched off
Mower does not
charge
Mower out of
perimeter wire
Parts of the lawn
area left uncut
Possible Cause
On/Off switch not turned on
Possible clogging
Battery not fully charged
Grass too long
Battery too hot/cold
Problems whilst running
Battery too hot/cold
Docking station not switched on
Charging pins corroded
Perimeter wire on a slope
Obstacle near perimeter wire
Mower requires more cuts to
finish garden
Time slot not long enough for
garden size
Distance between perimeter
wires too small
Rough mowing conditions
Grass too long
Slopes in garden too steep
Corrective Action
Remove mower out of docking station, turn On/Off switch
on and place mower back into docking station (ensure
docking station is on – LED lights up green) .
Always turn On/Off switch off first, then check
underneath the mower and clear out as necessary
(always wear protective gloves) .
Place mower in the docking station to allow to charge .
Docking station must be powered on .
Mow lawn with conventional lawnmower to its lowest
height-of-cut setting before using the mower .
The mower operates when the battery internal battery
temperature is between 5 °C – 45 °C . Allow mower to
cool down/warm up . If the error occurs frequently, the
docking station should be positioned in the shade .
Press confirm button for screen to light up, or place
mower in docking station .
The mower operates when the battery internal
temperature is between 5 °C – 45 °C . Allow mower to
cool down/warm up . If the error occurs frequently, the
docking station should be positioned in the shade .
Switch on power supply to docking station . If docking
station does not start, contact your Honda authorised
dealer .
Clean the charging pins .
Leave 30 cm between the perimeter wire and the slope
should be 15°/27% .
Remove obstacle .
Allow mower to run for 3 full cuts to cover whole lawn
area .
Increase mowing time slot or use Easy Timer Calendar
Function .
Increase distance between the perimeter wires to a
minimum of 75 cm .
Select "uneven ground/low sensitivity" option from menu
item "lawn condition/bump sensor" .
Flatten garden/remove/bumps/mark out unsuitable areas
with the perimeter wire – Please follow the instructions
in the Installation Guide .
Select "uneven ground/low sensitivity" option from menu
item "lawn condition/bump sensor" .
Ensure mower only operates on slopes of 15 degrees or
less and full garden is not on a slope .