Energy Saving Mode; Menu Navigation; Battery Charging - Honda MIIMO HRM40 Instructions Originales

To stop mowing prematurely, press the Stop button or
send the mower back to the docking station by pressing
the confirm button H.

Energy saving mode

The mower reduces its energy consumption by
automatically switching off the power to the perimeter
wire when it is not mowing and not being charged .
To wake up the mower manually from the energy saving
mode, press the confirm button H and afterwards select
either "Mow now" or another "Mowing mode", while the
mower is in the docking station .
When a schedule or the Easy Timer Function becomes
active, the wire signal will start up automatically .
Mowing small lawn areas with Place & Mow
Place & Mow is intended for mowing small areas that
require special treatment without having to mow the
whole lawn, such as the area under a piece of garden
furniture that has been removed . The mower is to be
positioned at the lower left corner of the intended area
to mow . (see figure H) . The finally mowed area depends
on the lawn conditions; it will not necessarily be an exact
square . After completion of Place & Mow, follow the
instructions on the screen .
Note: For safety reasons, Place & Mow cannot be used
outside the perimeter wire .

Menu Navigation

The table below explains the various menu items .
Main Menu Sub-menu 1
Mow now
Easy Timer
Calendar
Sensors
The mower is equipped with the following sensors:
– The lift-up sensor is activated when the mower is
lifted .
– The rollover sensor detects when the mower tips over .
– The tilt sensor is activated when the mower reaches a
slope angle of 32° .
When one of the sensors is activated, e .g . the lift-up
sensor, the drive motors and cutting blades are stopped .
A message is indicated in the display, e .g . "lift-up" .
– The obstacle sensor detects objects/obstacles
alongside the entire front edge of the mower and
causes a change of direction .

Battery charging

The battery is equipped with temperature monitoring that
allows charging only if the battery internal temperature is
in the range between 5 °C and 45 °C .
The lithium-ion battery is supplied partially charged . It is
recommended to charge the mower during installation of
the perimeter wire in the docking station .
The lithium-ion battery can be charged at any time
without reducing its service life . Interrupting the charging
procedure does not damage the battery .
When the battery is run flat or discharged, the mower is
shut off by means of a protective circuit: the blades no
longer move .
Sub-menu 2 Explanation
Pressing the confirm button will send the mower to mow .
In "Off/Manual" mode, the mower works until the display
shows "garden complete" .
In "Schedule" mode or with the Easy Timer Calendar
Function, the mower will operate until the end of the
time period or until the display shows "garden complete"
(whichever comes first) .
The Easy Timer Calendar Function is optimised based on
the size of the lawn area .
In the default setting, the mower does two full cuts a
week and starts at 8 am .
The following settings are possible:
Number of full 1 to 3
cuts per week
Weekday Days on which mowing is allowed (e .g . to exclude
Sundays) .
Start time Only possible to edit the first time slot (applies to all
active days) .
English | 11