Read This First; Important - Vent-Axia Svensa Guide D'installation

Important Information & Functions

READ THIS FIRST!

IMPORTANT!

Please read these instructions carefully before use. The fan is
designed for permanent installation and must be installed by
an authorized electrician.
According to the EN 60335 Standard, the following must
be taken into account:
This product can only be used by persons aged 12 years
and over, if they have received guidance or been instruc-
ted on the use of the product in a safe manner and are
aware of the risks. Children must not play with the product.
Cleaning and maintenance must not be carried out by
children. The fan channel length must not be less than
200mm. When mounting in wall or ceiling the external
opening must always be protected against rain/snow with
a hood/exterior grille.
4
FUNCTIONS
Automatic humidity control system
Fully automatic humidity control, which means the fan increases
the air flow at increased humidity. The air flow can be adjusted
from the control panel or via the app.
Air quality sensor
The fan is also equipped with an air quality sensor that increases
the air flow when the air is poor.
The air flow is the same as that selected for automatic humidity
control system.
Timer
Triggered via light sensor or igniter wire. Selectable run-on time
10 or 30 minutes (5/10/15/30/60 via the app). The air flow can
be adjusted from the control panel or via the app.
Continuous operation
Let the fan run continuously if you need basic ventilation in your
home. The flow can be adjusted from the control panel or via
the app. The duration of the program can also be adjusted via
the app.
Airing function
If the fan has been inactive for 26 hours, it will run an airing
program for 60 minutes.
The airing function is not active when the fan is running continu-
ously. The air flow can be adjusted from the control panel or via
the app.
App
The Vent-Axia Connect app can be downloaded to Android
and IOS phones. The app gives you access to a variety of
settings and functions. Press the light-air quality sensor-button
for 8 seconds until the light flashes to connect to the fan via
bluetooth. See page 26 for more information.
EN