Moving To/From Wheelchair - Vermeiren Trigo T-line Manuel D'utilisation

3.7.2 Backrest height (step adjustment)
1. Remove the back cushion.
2. Push the spring button located on the back of the back frame tube.
3. Move the backrest up/down to the desired height.
4. Make sure that the spring button clicks back in the corresponding hole.
5. Repeat for the other side. Make sure that both sides are set to the same height and
that they are firmly secured.
3.7.3 Push handle height (stepless adjustment)
Fixing lever
1.
Turn the push handle lever (40) to loosen it.
2.
Move the push handle up/down to the desired height.
3.
Secure the handle by tightening the lever(40).
4.
Repeat for the second push handle. Make sure that both
handles are set to the same height and that they are
firmly secured.
Fixing knob
1. Turn the push handle knob (30) a few turns anticlockwise.
2. Move the backrest up/down to the desired height by pulling
the handles.
3. Secure the backrest by tightening the knob; turn it clockwise.
4. Repeat for the other side. Make sure that both sides are set
to the same height and that they are firmly secured.
3.8

Moving to/from wheelchair

CAUTION
• In case you cannot perform the transfer in a safe manner, ask someone to assist you.
• Do not stand on the footplate during transfer into or out of the wheelchair.
Transfer
1.
Position the wheelchair as close as possible to you when sitting in your chair, couch,
seat or bed.
1.
Apply both parking brakes to block the movement, see §3.1.
2.
Turn the footrests to the side, or fold the footplates up to prevent standing on them.
3.
Transfer to/from the wheelchair using the strength of your arms or with the help of
attendant(s) or lifting equipment.
Risk of injuries and damage
11
Trigo T
2019-02
Using your wheelchair
40
30
EN
NL
PL
CS