Bartscher 162900 Mode D'emploi page 37

•
Place the device so that the plug is easily accessible for quick disconnection of the
device from power supply, if necessary.
•
Before the first use, remove the protective foil from the device. Remove the foil slowly
not to leave glue residues. Remove possible glue residues with appropriate solvent.
CAUTION!
Never remove the type plate and warning signs from the device.
Connection
DANGER! Electric shock hazard!
The device can cause injuries due to improper installation!
Before installation and connecting the local power grid
specification should be compared with that of the device (see
rating plate). Connect the device only in case of compliance!
•
Before connecting the power supply to the device, the local power grid specification
should be compared with the value of voltage and frequency on the type plate.
Permissible voltage tolerance is ± 10%.
•
Make sure that there is a power connection available which is consistent with the
applicable regulations. During the connection to the electrical installation, use the
cable with sufficient cross-section.
•
A multipolar switch must be switched on between the device and the electrical
installation, appropriate for the device's power. The switch with at least 3 mm
opening must be easily accessible.
•
Connection to the power supply installation must comply with the applicable
international, national and local regulations.
- 33 -