Controls & Settings; Wash Cycle Selections; Wash Options; Functions - IKEA VILLKORLIG Mode D'emploi

CONTROLS & SETTINGS
Wash Cycles

Wash cycle selections

Cycle times are approximate and will
vary with the options selected. Hot
water is necessary to activate the
detergent and melt fatty food soils. An
automatic sensor will check the incoming
water temperature. If it is not at the
appropriate temperature the timer will
delay the cycle to allow automatic water
heating during the main wash. When the
Hi Temp wash is selected an even higher
temperature will be assured to handle
heavier soil loads.
Wash cycles
AUTO
Auto Cycle uses sensors in the dish
washer to determine the soil level of the
dish load, then adjusts the wash cycle to
optimiz e the wash performance, water
and energy usage.
HEAVY
Recommended for pots, pans, casseroles
and dinnerware having heavily soiled
loads.
NORMAL
Recommended for lightly to heavily
soiled loads.
FAST
A shorter wash recommended for lightly
soiled loads.
RINSE
Recommended for pre-rinsing dishes or
glasses. This is only a rinse that keeps
food from drying on your dishes and
reduces odor buildup in your dishwasher
until you are ready to wash a full load.
Do not use detergent.

Wash options

HI TEMP
When Hi Temp is selected, the
temperature of the water will be
maintained at 140°F (60°C) max.
8
Wash Options
SANITIZE
When Sanitize is selected, the
temperature of water will be maintained
at 156.2°F (69°C) max. The max
temperature may not be reached if
the incoming water temperature is not
correct. Certified residential dishwashers
are not intended for licensed food
establishments.
The Sanitize option is only available
with Heavy and Normal wash cycles.
HEAT DRY
When Heat Dry is selected, the heater
will work during the drying process.

Functions

START
Press START and close door within
4 seconds to start a wash cycle.
CANCEL
Press CANCEL to cancel a cycle that is
already in progress.
DELAY
The Delay option allows you to
automatically delay starting your
dishwasher from 1-24 hours. To start
1-24 hour delay, press the Delay button
until the desired delay time shows in
the display window (1h-24h) and press
the START button. A light will come
on indicating the delay start has been
activated and will remain on until the
cycle starts. To cancel the delay option
and begin the cycle before the delay
period is over, press the Cancel button.
CONTROL LOCK
Use to lock all controls and prevent
children from accidently changing
the dishwasher cycle or starting the
dishwasher. Press and hold Heat Dry for
3 seconds to lock. After the function is
selected the control lock illuminate. Press
and hold again for 3 seconds to unlock.
Functions Cycle Indicator
WARNING
EN