IKEA VILLKORLIG Mode D'emploi page 17

EN
Before calling for service, review this list. If may save you both time and expense.
This list includes common experiences that are not the result of defective
workmanship or material in your dishwasher.
To achieve the best results from your dishwasher, visit www.dishwashingexpert.com
for general tips regarding the performance and operation of your dishwasher.
PROBLEM
Dishwasher
won't start
Dishwasher
beeps at the
end of the cycle
Dishwasher
operates too
long
Dishes are not
clean enough
POSSIBLE CAUSES
• Dishwasher door is
open.
• Power supply or
power line is not
connected.
• Delay option has
been selected.
• Control Lock
activated
(select models).
• The wash cycle will
beep to indicate the
end of the cycle.
• The dishwasher is
connected to cold
water.
• The cycle time will
vary due to the
soil.
• The sanitize option
is selected.
• Water pressure is
temporarily low.
• The inlet water
temperature is low.
• Dishes are loaded
too close together.
• Improper use of
detergent.
• The selected cycle
is not suitable for
food soil condition.
• Spray arms is
blocked by
some items.
TROUBLESHOOTING
SOLUTIONS
• Shut the door completely make sure
it is latched.
• Check and connect the power
supply.
• Refer to the Delay section in this
manual to reset.
• Deactivate the control lock, refer to
Control Lock section in this manual.
• Check the dishwasher, make sure
it is properly connected to the hot
water supply.
• When heavy soil is detected, some
cycles will automatically increase
the cycle time.
• When sanitize option is selected, the
cycle time will be increase to meet
the sanitized temperature request.
• Use you dishwasher when the water
pressure is normal.
• Make sure the dishwasher is
connected to the hot water supply
Try not use your dishwasher when
hot water is being used elsewhere in
the house.
• Load the dishes again as per the
manual.
• Add detergent depending on the
water hardness and the cycle you
chose. Use fresh detergent.
• Choose anther cycle for longer
washing time.
• Make sure the spray arm is rotated
freely.
17