Remote Electronics (Up To 50M) 20-0005-Ip - Telecom Behnke 5 Serie Manuel

Instructions for Behnke SIP 2.0
GB
Hardware

4.2. Remote electronics (up to 50m) 20-0005-IP

Sub circuit board
Suitable installation material for adaptation of
speaker, microphone and buttons at the door:
branch-off box 20-9251
Clamps buttons 1 to 8
potential-free buttons, max. 50m wire length +
min. 0.14mm² cross-section
(cf. page 47) (configurations steps 21 to 28)
Microphone
(please maintain the polarity!)
GND + 12V
Alarm in
unlined
Speakers
Connections
for key pad max. 50m
Alarm in
56
Please note: Operation only possible in conjunction
with connection box 43-9251. Please see the manual for
connection box 43-9251 for a detailed description of the
wiring between 20-0005-IP and connection box 43-9251
–
5VDC – 24 VDC 5VDC – 24 VDC
+
Connection for extensions
LAN receptacle INPUT
(SIP intercom station to Switch)
Network connection
PORT 2
(receptacle for additional IP devices,
e.g. an IP camera. Please adhere to the
technical data of the Switchport).
Master CPU
T1 + T2
Buttons to display device information
(cf. p. 58)
LEDs:
Red:
blue: ready
Green: Registered on SIP server
Plug for module illumina-
tion (12V) / Illumination for
Behnke wide angle IP camera
exclusively intended to branch Behnke
labels and Behnke cameras with
illumination. Non-compliance can lead
to a circuit board defect.
Relay 2
max. switching voltage: 60VDC/50VAC
max. switching current: 2A
max. switching cable max 62,5VA/60W
Please note that none of the above
specifications may be exceeded
Relay 1
max. switching voltage: 60VDC/50VAC
max. switching current: 2A
max. switching cable max 62,5VA/60W
Please note that none of the above
specifications may be exceeded
Earthing
needed in case a
TNV-1 circuit is used (e.g. devices to be
mounted in a column without connection
to the building)
Ethernet connection
1: white-green
according to EIA/TIA 568 A
2: green
3: white-orange
6: orange
www.behnke-online.de
Power supply PoE
(LED illuminated: PoE available)
(LED flashing Device "booting")
(max 5 min)
Make contact
Control contact
Rest contact
Make contact
Control contact