Informations For Energy-Saving Use; Tips - V-ZUG NOBLESSE 51028 Mode D'emploi

– For cleaning the control element please
use only a humid flannel.
– Be careful that as little cleaning water as
possible goes though the drainage
channel into the collection dish.
– Before being put back in use, the appli-
ance and the seals of the cold room and
the freezer must all be completely dry.

Informations for energy-saving use

As far as possible, use the cooling unit in
■
its as-delivered state. The arrangement
of drawers, shelves and trays ensures the
best possible temperature distribution.
Do not install the unit near radiators,
■
radiator pipes or smoke extractors and
protect it as far as possible from direct
sunlight
Make sure the unit doors are kept open
■
for as short a time as possible. The
quicker the doors are closed again, the
less cold is lost.
Make sure that the doors are closed fully
■
and correctly. The door seal must be
flush against the frame of the fridge.
Leave warm or even hot items to cool
■
down outside the unit.
The storage of moisture-releasing food-
■
stuffs leads to increased build-up of ice
on the rear of the fridge and a reduction
in cooling power.
34

Tips

The following points should be noted
when using the new appliance:
A appliance which has just been put into
■
use needs approx. 15 hours (with prod-
ucts) until it has reached its normal oper-
ating temperatures.
If the doors are open for longer than
■
2 minutes then the lamp starts to flash.
Make sure after closing that the doors
are fully sealed. The self-closing hinges
assist this.
The cooling time for beverages and other
■
products can take up to 6 hours from
room temperature down to the cold
room temperature. The warmer they are
when put in, the longer this time will be.
Re-setting the temperature control has
■
no effect on the cooling rate, only on
the temperature reached.
Condensation can form on the glass
■
shelves if products are stored which emit
water vapour.
As the electronic control in the cold
■
room only defrosts about once per day,
the ice formation on the rear wall in the
cold room itself can be more marked
than is usual in previous refrigerators.