Cold Room; Cleaning; Informations For Energy-Saving Use - V-ZUG FUTURA 51020 Mode D'emploi

Cold room

The height of the glass shelves can be
adjusted individually. Pulling both holders
sideways inwardly (Figure
fixation turn them down and backwards
(Figure b). Pull the glass shelf out of the
7
guidance and replace it in reversed order
at the desired position.
a
7
7 b
28
a) and for
7

Cleaning

The appliance is to be kept clean for the
hygienic storage of foodstuffs. It should be
washed out from time to time with a mild
soapy solution and then dried. An occasio-
nal wiping with a vinegar solution suppres-
ses odours and is recommended. Keeping
the door seals clean stops them from sti-
cking and thus avoids them being dama-
ged. No scouring cleaners or scratching
cloths are to be used. Clean the door seals
with a soft brush. If the appliance has not
been used for some time, turn off by using
the main switch. Empty the appliance,
defrost it, clean, and then leave the cold
room as well as the freezer compartment
open.
– For cleaning the control element please
use only a humid flannel.
– Be careful that as little cleaning water as
possible goes though the drainage
channel into the collection dish.
– Before being put back in use, the appli-
ance and the seals of the cold room and
the freezer must all be completely dry.

Informations for energy-saving use

As far as possible, use the cooling unit in
■
its as-delivered state. The arrangement
of drawers, shelves and trays ensures the
best possible temperature distribution.
Do not install the unit near radiators,
■
radiator pipes or smoke extractors and
protect it as far as possible from direct
sunlight
Make sure the unit doors are kept open
■
for as short a time as possible. The qui-
cker the doors are closed again, the less
cold is lost.