Cleaning And Maintenance; General Cleaning; Cleaning Of The Nozzle / Tip Replacement - Roca In-Wash In-Tank A803094001 Mode D'emploi

4. CLEANING AND MAINTENANCE

❚

4.1 GENERAL CLEANING

CLEANING OF THE REMOTE CONTROL
Clean it softly with a wet cloth.
If the remote control is very dirty, you may use dilu-
ted neutral detergent.
Do not remove the cover of the batteries during its
cleaning.
CLEANING OF THE DEVICE
Clean the outside of the device with care using a soft and wet cloth or a sponge.
Important:
1. Do not use aggressive products such as bleaches or ammonia. Use only neutral product.
2. Do not pull or push the nozzle manually. To remove it see section 4.2
3. While cleaning the WC leave the cover open for a few hours so that gases do not enter the In-Wash.
4. Do not spray the water or the air outlets with water or cleaning agents that may enter inside the In-Wash.

4.2 CLEANING OF THE NOZZLE / TIP REPLACEMENT

❚
We recommend cleaning the nozzle and the tip weekly.
The e-bidet is provided with one additional tip with 3 holes for a more intense cleaning. This second tip can be used to replace the installed tip.
To remove the nozzle or change the tip, follow this steps:
1
3 s.
4
A
B
7
B
A
1- Press the anal cleaning button on the auxiliary side control for 3 seconds.
2- The lights blink and a beep can be heard (if the silence mode is not activated).
3- The nozzle will come forward without spraying any water.
4- Remove the tip by rotating it in an anti-clockwise direction.
5- Clean the nozzle.
6- Clean the tip.
7- Replace the tip on the nozzle.
8- Once the cleaning is finished, press the Stop button on the remote control or the auxiliary side control. Should
you fail to do so, the nozzle will move backwards automatically after 5 minutes. Once inside, it carries out a
self-cleaning process.
Hard
Cl
2
x1
5
8
3
6
Ó
neutral
soft
CR 2032 (x1)
CR 2032 (x2)
23