Technical Features; Features / Specifications; Disposal Of Electric And Electronic Products - Roca In-Wash In-Tank A803094001 Mode D'emploi

PROBLEM
The temperature of the drying air is not warm
enough.
The seat moves when sitting down.
*
Should the problem persist, please call the Technical Assistance.

6. TECHNICAL FEATURES

❚

6.1 FEATURES / SPECIFICATIONS

SPECIFICATIONS
Model
Power supply
Frequency
Max. power input
Heat output
Temperature range
Water pressure
Cleaning
Drying
Length of the connecting cable
Remote control
Night light
Energy savings
Size of the product
Weight of the product
Protection class
Consumption in stand-by

7. DISPOSAL OF ELECTRIC AND ELECTRONIC PRODUCTS

NOTE: This symbol and recycling system is only applicable in the European Union. It does NOT apply to the rest of the world.
At ROCA we are committed to protecting the environment. Please help us by discarding this product at the end of it life-cycle in a res-
ponsible manner, to prevent that certain substances contained in electrical or electronic equipment may cause harm to human health
and the environment.
The crossed-out wheeled bin symbol, shown above and on the product, means that it should not be discarded with other household
waste. At the end of the product's life-cycle, it must be delivered to the corresponding collection facilities enabled by the authorities in
your country or to the supplier from which you purchase a product of equivalent type or that fulfills the same functions as the previous
equipment. This last option may not be available in some countries, so please check with the authorities in your country about the collec-
tion systems available and the collection facility closest to your home.
This way, you can cooperate with the protection of the environment through the reuse and recycling of waste electrical and electronic equipment. On
the contrary, administrative responsibilities can be derived for you in case of non-compliance with the rules for the delivery of the waste of this product.
Batteries shall be previously removed and discarded separately in suitable recycling containers.
POSSIBLE CAUSE
The temperature of the drying air is set to room
temperature.
The air heater is not working.
The rear brackets of the seat are not tight enou-
gh.
Water heater
Hot air dryer
Service temperature
Water temperature 4 levels
Temperature of the warm air dryer 4 levels
Storage temperature
Flow perineal position
Flow anal position
Safety devices
Air speed of the dryer
Safety device
Wall-hung model
Floorstanding model
Wall-hung model
Floorstanding model
SOLUTION
Increase the temperature by means of the remote
control.
*
Tighten the rear brackets of the seat.
In-Wash + In-Tank
220-240V AC
50/60Hz
1700W
1650 W
300 W
10ºC / 30ºC
OFF / 33 / 36 / 39ºC
OFF / 40 / 50 / 60ºC
-10ºC / 60ºC
0,05 Mpa / 0,9 Mpa (0,5 bar - 9 bar)
0,45 – 0,55 – 0,65 l/min
0,65 – 0,75 – 0,85 l/min
Fuse and Thermostat
8,5 m/s
Fuse
1,5 M
Button batteries (CR2032) x2
Radio frequency (band 2,4GHz )
Yes
Automatic intelligent energy savings
L562×W385×H420 (mm)
L675×W385×H790(mm)
31 kg (±1kg)
55 kg (±1kg)
IP X4
<0,7W
27