Turning Off (Stand-By) / Reset Of The Product; Cleaning And Maintenance; General Cleaning; Cleaning Of The Nozzle / Tip Replacement - Roca IN-WASH INSPIRA Mode D'emploi

❚

3.6 TURNING OFF (STAND-BY) / RESET OF THE PRODUCT

To switch off the In-Wash, press the Stop button on the auxiliary side control for 3 seconds.
To reactivate the In-Wash, press the Stop button on the auxiliary side control.
From that moment on the device carries out a power self-calibration for 2 minutes; during this period of time
water flows out of the nozzle.
Do not disconnect the device during this process.
RESET
The reset process consists in a stand-by manoeuvre followed by the activation of the product.
Each time this process is carried out, a power self-calibration will be carried out for 2 minutes.

4. CLEANING AND MAINTENANCE

4.1 GENERAL CLEANING

❚
CLEANING OF THE REMOTE CONTROL
Clean it softly with a wet cloth.
If the remote control is very dirty, you may use dilu-
ted neutral detergent.
Do not remove the cover of the batteries during its
cleaning.
CLEANING OF THE DEVICE
Clean the outside of the device with care using a soft and wet cloth or a sponge.
Important:
1. Do not use aggressive products such as bleaches or ammonia. Use only neutral product.
2. Do not pull or push the nozzle manually. To remove it see section 4.2
3. While cleaning the WC leave the cover open for a few hours so that gases do not enter the In-Wash.
4. Do not spray the water or the air outlets with water or cleaning agents that may enter inside the In-Wash.

4.2 CLEANING OF THE NOZZLE / TIP REPLACEMENT

❚
We recommend cleaning the nozzle and the tip weekly.
The e-bidet is provided with one additional tip with 3 holes for a more intense cleaning. This second tip can be used to replace the installed tip.
To remove the nozzle or change the tip, follow this steps:
1
3 s.
4
A
B
7
B
A
1- Press the anal cleaning button on the auxiliary side control for 3 seconds.
2- The lights blink and a beep can be heard (if the silence mode is not activated).
3- The nozzle will come forward without spraying any water.
Hard
Cl
2
x1
5
8
3
6
Ó
3 s.
neutral
soft
21