Before Operation; Preparing The Battery - Metabo HPT STRAP-TITE NR 3665DA Manuel D'instructions Et De Sécurité

○ Charging a USB device from a electrical outlet
○ Charging a USB device and battery from a
electrical outlet
(2) Turn the USB power switch ON
When you turn the USB power switch ON, the USB
power indicator lamp will light up.
Rubber cover
USB cable USB port
(3) Connect the USB cable.
Pull back the rubber cover and fi rmly plug in a
commercially available USB cable (appropriate to the
device being charged) into the USB port.
○ When the power cord is not plugged into an outlet
and the battery runs out of power, power output will
stop and the USB power indicator lamp will shut off .
○ When the USB power indicator lamp goes out,
change the battery or plug the power cord into an
electrical outlet.
(4) When charging is completed
○ The USB power indicator lamp will not go out when a
USB device has been completely charged.
To verify charge status, check the USB device.
○ Turn the USB power switch OFF and unplug the
power cord from the electrical outlet.
○ Remove the battery from the charger and place the
rubber cover over the USB port.
USB power
switch
USB power
indicator lamp

BEFORE OPERATION

Read section titled "SAFETY" (pages 3–11).
Make sure of the followings before operation.

PREPARING THE BATTERY

Read section titled "SAFETY, IMPORTANT SAFETY
INSTRUCTIONS FOR BATTERY CHARGER" (page 28).
You must charge the battery before use.
The charging method of battery is shown in page 16–18.
HOW TO OPERATE OPERATION
PANEL
Power
switch
Power indicator
Information indicator
(1) Power switch ON
Under the condition of "Power switch OFF", push
and hold on Power switch more than 1 second, then
power indicator lights in Green.
NOTE
● Do not press the push lever and/or pull the trigger
during the process of turning the power switch ON.
Doing so will prevent the power switch from turning
ON.
OFF
Light in green
ON
English
Nailing operation
indicator
19