Nailer Safety Warnings; Important Safety Instructions For Using Nailers - Metabo HPT STRAP-TITE NR 3665DA Manuel D'instructions Et De Sécurité

NAILER SAFETY WARNINGS

– Always assume that the tool contains fasteners.
Careless handling of the nailer can result in
unexpected fi ring of fasteners and personal injury.
– Do not point the tool towards yourself or anyone
nearby. Unexpected triggering will discharge the
fastener causing an injury.
– Do not actuate the tool unless the tool is placed
fi rmly against the workpiece. If the tool is not in
contact with the workpiece, the fastener may be
defl ected away from your target.

IMPORTANT SAFETY INSTRUCTIONS FOR USING NAILERS

1. OPERATORS AND OTHERS IN WORK AREA MUST WEAR SAFETY GLASSES WITH SIDE SHIELDS.
When operating the Nailer, always wear safety glasses with side shields, and make sure others in work
area wear safety glasses, too.
Safety glasses must conform to the requirements of American National Standards Institute, ANSI Z87.1
and provide protection against fl ying particles both from the front and side.
The employer must enforce the use of safety glasses by the Nailer operator and others in work area.
2. DO NOT USE THE NAILER TO DRIVE FASTENERS INTO HARD MATERIALS SUCH AS METAL OR
CONCRETE.
The Nailer is designed for use with pre-punched holed metal connector only.
If fasteners are driven into hard materials, the fasteners can ricochet and hurt someone.
3. TO OPERATE THE NAILER, HOLD PERPENDICULAR TO THE WORKPIECE.
SAFETY
— Continued
WARNING
–
–
–
READ ALL INSTRUCTIONS
DANGER
Metal connector
Wood
Disconnect the tool from the power source when
the fastener jams in the tool. While removing a
jammed fastener, the nailer may be accidentally
activated if it is plugged in.
Use caution while removing a jammed fastener.
The mechanism may be under compression and
the fastener may be forcefully discharged while
attempting to free a jammed condition.
Do not use this nailer for fastening electric cables.
It is not designed for electric cable installation and
may damage the insulation of electric cables thereby
causing electric shock or fi re hazards.
English
5