Leister GEOSTAR G5 Instructions D'utilisation page 42

Working display overview
Readiness
Standby mode is activated.
If the engine is switched
off , the heating activated
and if no button is ac-
tivated during the time
defi ned under "Standby
interval", then the device
will switch over automati-
cally into Standby display.
If the «e-Drive»
pressed during the subse-
quent 180 seconds, then
the heating will shut off au-
tomatically. "Standby" will
then appear afterwards
on the display. Pressing
«e-Drive» causes the
device to switch to Work-
ing mode .
Standby mode is deactivat-
ed in the factory settings.
Gear Ratio Drive
The value (slow/fast) must
match the sprocket wheel
arrangement in the gear-
box. Chapter "Change gear
speed"
42
is not
Show Duty Info
Hours Drive:
Current running time
of the drive
Hours Heating:
Current running time
of the heater
Hours Machine:
Current running time
of the machine
Day Distance:
Currently traveled distance
(can be reset)
Total Distance:
Total distance traveled.
Show General Info
Firmware HMI:
Software version of
thedisplay unit
(communications module).
Firmware Machine:
Software revision
Production Info:
Information on date
of production and
production number
Warning display
If there is a warning pend-
ing, this is indicated by the
symbol in the status dis-
play. The "Warnings" menu
contains more detailed in-
formation about the current
warning.