After Using The Machine - Viper AS5160 Mode D'emploi

USER MANUAL
CAUTION!
If the vacuum system turns off accidentally
(for example, when the float is activated
because of a sudden machine movement), to
resume the operation: turn off the vacuum
system by pressing the switch (D, Figure 10),
then open the cover (C, Figure 11) and check
that the float inside the grid (A) has gone
down to the water level. Then close the cover
(C) and turn on the vacuum system by
pressing the switch (D, Figure 10).
When the recovery water tank (B, Figure 11) is full, empty it
according to the following procedure.
Recovery water tank emptying
1. Stop the machine.
2. Lift the brush/pad-holder deck (E, Figure 10) by pressing
the pedal (F, Figure 10). (only for disc machine)
3. Lift the squeegee (G, Figure 10) with the lever (H,
Figure 10).
4. Drive the machine to the appointed disposal area.
5. Empty the recovery water tank with the hose (I, Figure 10).
Then, rinse the tank (B, Figure 11) with clean water.
CAUTION!
When draining the wastewater, the vacuum
tube for waste must be folded (A, Figure 12)
and lowered to a lower position (B, Figure 12),
and then open the lid of the vacuum tube for
waste to drain the water. Do not make the out-
let of the vacuum tube for waste face upward
to drain the water vertically. This is to avoid
wastewater spilling onto the operator.
6. Perform steps 1 to 4.
Solution/clean water tank emptying
7. Empty the solution tank with the outlet cover (A, Figure 13).
After working, rinse the tank with clean water.

AFTER USING THE MACHINE

After working, before leaving the machine:
1. Remove the brushes/pad-holders.
2. Empty the tanks (B and C, Figure 13) as shown in the
previous paragraph.
3. Perform the daily maintenance procedures (see the
Maintenance chapter).
4. Store the machine in a clean and dry place, with the brushes/
pad-holders and the squeegee lifted or removed.
19
ENGLISH
C
B
A
Figure 11
Figure 12
C
D
A
Figure 13
A
B
B