Tank Emptying; After Using The Machine; Machine Long Inactivity - Viper AS530R Manuel D'utilisation

USER MANUAL

TANK EMPTYING

An automatic float shut-off system (B, Figure 13) blocks the vacuum system when the recovery water tank (C) is full. The
vacuum system deactivation is signaled by a sudden increase in the vacuum system motor noise frequency, also the
floor has not dried.
CAUTION!
If the vacuum system turns off accidentally, (For
example, when the float is activated because of a
sudden machine movement), to resume the
operation: turnoff the vacuum system by pressing
the switch (D, Figure 12), then open the cover (A,
Figure 11) and check that the float inside the grid
(B) has gone down to the water level. Then close
the cover (A) and turn on the vacuum system by
pressing the switch (D, Figure 12).
When the recovery water tank (C, Figure 13) is full, empty it
according to the following procedure.
Recovery water tank emptying
1. Stop the machine.
2. Lift the brush/pad deck (H, Figure 12) by pressing the pedal (G).
3. Lift the squeegee with the lever (H).
4. Drive the machine to the appointed disposal area.
5. Empty the recovery tank with the drain hose (D). Then rinse the
tank with clean water.
CAUTION!
When draining the wastewater, the drain hose
must be folded (A, Figure 14) and put to a low
position (B, Figure 14) before opening the drain
hose cover. Do not make the outlet of the drain
hose upward to drain the water vertically in order
to avoid wastewater spilling onto the operator.
Solution/clean water tank emptying
6. Perform steps 1 to 4 in chapter "Recovery water tank emptying".
7. Empty the solution tank through the outlet cover (A, Figure
15). And then, rinse the tank with clean water.

AFTER USING THE MACHINE

After working, before leaving the machine:
1. Remove the brushes/pad-holder.
2. Empty the tanks (B and C, Figure 15) as shown in previous
paragraph.
3. Perform the daily maintenance procedures (see the
Maintenance chapter).
4. Store the machine in a clean and dry place, with the
brushes / pad-holders and the squeegee lifted or removed.

MACHINE LONG INACTIVITY

If the machine is not going to be used for more than 30 days,
proceed as follows:
1. Perform the procedures shown in "AFTER USING THE
MACHINE" paragraph.
2. Disconnect the battery connector (D, Figure 15).
G
Figure 13
B
Figure 15
14
ENGLISH
H
F
Figure 14
141414 14
D
A
B
C
D
E
A
B
C
A