Battery Charging; Preliminary Procedures - Viper AS5160 Mode D'emploi

Masquer les pouces Voir aussi pour AS5160:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

USER MANUAL

BATTERY CHARGING

NOTE
Charge the batteries when the yellow (F,
Figure 14) or red warning light (G) turns
on, or when finishing cleaning.
CAUTION!
Keeping the batteries charged make their
life last longer.
CAUTION!
When the batteries are discharged, charge
them as soon as possible, as that condition
makes their life shorter. Check for battery
charge at least once a week.
WARNING!
WET battery charging produces highly
explosive hydrogen gas. Charge the batte-
ries in well-ventilated areas and away
from naked flames. Do not smoke while
charging the batteries. Keep the tank open
while charging the batteries.
WARNING!
Pay careful attention when charging the
batteries as there may be battery fluid lea-
kages. The battery fluid is corrosive. If it
comes in contact with skin or eyes, rinse
thoroughly with water and consult a phy-
sician.

Preliminary procedures

1.
Open the cover (A, Figure 14) and check that the recovery water tank (B) is empty, otherwise empty it with
the drain hose (C).
2.
Drive the machine on a level floor.
3.
Turn the ignition key (H) to "0".
4.
Carefully lift the tank (B).
5.
For WET batteries, only:
Check the level of electrolyte inside the batteries (D); if necessary, top up through the caps (E).
Leave all the battery caps (E) open for next charging.
If necessary, clean the upper surface of the batteries (D).
6.
Charge the batteries according to the following procedure.
C
E
D
21
ENGLISH
H
G F
D
Figure 14
B
A

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

As5160tAs516to500004015000040650000539

Table des Matières