General Problems - BRIGHT 018208 Mode D'emploi

TROUBLESHOOTING
The troubleshooting guide is used to identify the causes of common problems and how they can be rectified. Contact your dealer if you
experience a problem that is not included in this troubleshooting guide.
Technical problem
Symptom
The appliance does not start.
The water does not pump out.

General problems

Symptom
Foaming
Stains inside the appliance.
White deposits inside the
appliance.
Rust stains on metal objects
Noise
Symptom
Knocking noise during
dishwashing.
Rattling noise during
dishwashing.
Knocking noise in the
water pipe.
Possible cause
Fuse or switch tripped.
No power supply.
The panel is not properly closed.
The drain hose is clinched
The filter is blocked.
The sink drain is blocked.
Possible cause
Unsuitable detergent.
Rinse-aid spillage.
Coloured detergent has been
used.
Hard/mineral-rich water.
The objects are not resistant to
corrosion
Salt in the dishwater, because
the appliance has not be run
after filling with salt.
The lid on the container for
softener salt is loose.
Possible cause
The rinse arm is knocking
against an object.
An object is moving when it is
touched by the water jets.
Depends on the shape/or
diameter of the water pipe.
Action
Replace or reset fuse or switch. Disconnect any other appliances
connected to the same circuit.
Check that the appliance is switched on and that the panel is
properly closed.
Check that the power cord is plugged in and that the power point
is supplied with voltage. Check that the panel is properly closed
and locked.
Check the drain hose
Check and clean the coarse filter according for cleaning the filter.
Check that the sink drain is working properly. Clear the sink drain,
if necessary.
Action
Only use detergents intended for dishwashers. Open the panel and
wait until the foam has dissolved. Pour 3.75 l of cold water into the
dishwasher. Close the panel and run a wash programme to pump
out the water. Repeat, if necessary.
Wipe up any spilled rinse-aid immediately.
Only use uncoloured detergent.
Clean the inside of the appliance with a sponge moistened with a
detergent for dishwashers. Wear rubber gloves. Do not use other
detergents – risk of foaming.
Always run a quick programme without dishes and without the
Turbo function (if available) after filling with dishwasher salt.
Check the seal and tighten the lid.
Action
Stop the appliance and move the object.
Stop the appliance and move the object.
This does not affect the function of the dishwasher. Contact a
plumber, if necessary.
EN
57