Charging The Battery; Discharged Battery Signal; Maintenance; The N-Com Range Of Products - Nolan N-Com Sécurité Et Instructions D'utilisation

NOLAN nCOM bluetooth 0024
Caution: Only use the types of batteries, battery chargers and accessories approved by Nolan for your own device model.
- Unplug the battery charger from the mains and from the device when it is not used. Do not leave the battery connected
to the battery charger for long periods of time. Extreme temperatures may affect the recharging capacity of the battery.
- Do not use batteries for purposes that differ from the recommended ones. Never use battery charger or batteries that turn
out to be damaged.
- Do not short-circuit the battery.
- Always keep the battery at a temperature between 10°C and 35°C.
- Do not throw batteries into a fire! Batteries must be disposed of in compliance with local regulations. Do not throw the
batteries out with household waste.
- Only use the battery charger provided with your system. Do not charge the battery using other devices.
- If the system is not going to be used for a long period of time, remove the e-box from the helmet.

9.3. Charging the battery

The battery has to be completely recharged for at least 10 hours before using the N-Com. For optimum battery performance, it
is recommended to always carry out complete recharging cycles for the first charges. Subsequently, the battery can be recharged
for shorter time periods. Whenever possible, it is better to carry out a complete recharging cycle.
The Battery Charger in certain markets is not fitted with an L.E.D. battery status indicator, in this instance please note that
the complete charging process takes approximately 3 hours

9.4. Discharged battery signal

During operation, the system signals when the battery runs down and goes in "Reserve". When the battery has less than
L L
2-hour energy, also " " e "
means of 3 consecutive acoustic signals approximately every 6 minutes.

10. MAINTENANCE

The N-Com does not require any special maintenance tasks.
In case you use the kit when it rains, remove the e-box from its housing and dry it with warm air. Wipe dry the outside of the
helmet when wet, especially in the contact area.
In case the kit gets wet several times, rust or corrosion may form, thus hindering the electrical contact. In these cases, it is
recommended to clean the contacts of the socket on the shell and on the e-box using alcohol or another antirust product.

11. THE N-COM RANGE OF PRODUCTS

11.1. Basic kit

This is the minimum equipment that can be easily mounted on Nolan helmets preset for N-Com communication systems. It
consists of a pair of loudspeakers and a microphone.
23-05-2006 16:15
1. Connect the battery charger to the mains. The green light on the
FIG. 11
battery charger turns on.
2. Plug in the battery charger connector into its socket (fig. 11) in the
helmet. The red light on the battery charger lights up to indicate that
the connector is plugged in correctly and that recharging is in
progress.
3. The light turns green again when recharging is complete. Unplug the
connector and disconnect the battery charger from the mains.
" keys start flashing to signal the "Reserve" status. The "Reserve" status is indicated by
31
Pagina 31
ENGLISH