Electronic Oven Control; Electronic Oven Control Pads; Special Oven Control Functions - Amana ZRRSC8050 Serie Manuel Du Propriétaire

Electronic Oven Control

TIMING
TIMER
CLOCK
ON/OFF
STOP COOK
TIME TIME

Electronic Oven Control Pads

TIMER ON/OFF
• Use to time any kitchen function or cancel timer.
• Does not control bake, broil, or clean function.
CLOCK
• Use to set time of day.
STOP TIME
• Use to set delayed bake or delayed self-clean.
COOK TIME
• Use to set delayed or timed bake.
CLEAN
• Use to select self-clean cycle.
BROIL
• Use to select broil.
BAKE
• Use to select bake.
CONV .
• Use to select convection.
or —Used to set temperature or time.
OVEN CANCEL
• Cancels any cooking or cleaning function except
timer.
LIGHT
• Used to turn on and off light inside oven.
DELAY BAKE CLN STOP TIMER
CLEAN BROIL

Special Oven Control Functions

Timer Signal—When time elapses timer beeps 3 times
then once every 10 seconds.
Preheat Signal—After setting oven to bake and selecting
a temperature, oven preheats. When oven reaches set
temperature, oven signal sounds 3 times.
End of Cycle Signal—When a timed cooking cycle is
complete, three long signals sound. After first 3 signals,
1 signal sounds approximately every 10 seconds for 5
minutes or until OVEN CANCEL pad is pressed.
Child Lock Out — This is a safety feature that can be
used to prevent children from accidently programming the
oven. It disables the electronic oven control. Touch and
hold Bake and Cook Time for 10 seconds. "OFF" will
display where the temperature normally appears.
To reactivate the control, touch and hold Bake and Cook
Time for 10 seconds. Child lockout features must be reset
after a power failure.
12 Hour Automatic Cancel—This is a safety feature that
prevents oven from continuing to operate if it has been left
on for over 12 hours. If a cooking function continues longer
than 12 hours without any options on oven control being
touched, this feature turns oven off. Any time an option is
touched, 12 hour automatic cancel is reset.
Increasing
temperature, hold pad to accelerate the rate at which the
numbers increase or decrease.
Self-diagnostic System—Electronic range control has a
self-diagnostic system. Self-diagnostic system sounds a
series of short, rapid beeps and shows a "F-code" in
display when there is a problem. See "Service Tones and
Codes" section.
11
BROIL CONV
DELAY BAKE
CLEAN LOCKED
BAKE CONV.
or Pad Speed—When setting time and
TIME / TEMP SET
OVEN
CANCEL
LIGHT