Programming The System Operation - NSK Surgic Pro2 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 108
Setting
8 – 3 Programming the system operation
Eight programs can be memorized and recalled according to treatment procedures�
1
Press
to select a program number�
2
Press
to select the rotation direction:
Forward rotation (clockwise)
Reverse rotation (counterclockwise)
* Beep sounds constantly when reverse rotation is
selected�
3
Press
to select gear ratio for handpiece used�
4
Press
to set the maximum rotation speed�
* When rotating: displays actual speed
* When stopped: displays maximum speed set�
* Beep sounds when upper or lower limit is reached�
6
2
7
5
Press
Reduction contra with rotation speed of 100min
less only)
* Stops once at 50N•cm� If setting to greater than
55N•cm, press
* Beep sounds when upper or lower limit is reached�
* No display when the gear ratio is other than 20:1�
6
Press
to select coolant solution flow level�
7
Press
to select light brightness�
8
Press
to memorize setting (Memorizing is
complete when long beep sounds)�
38
4
5
3
8
1
to set torque upper limit (20:1
again�
or
-1

Publicité

Table des Matières
loading

Table des Matières