TFA Dostmann Mode D'emploi page 6

EASY-CHARGE WIRELESS
Digital alarm clock with induction charger
Cat. No. 60.2030.01
Delivery contents:
Digital alarm clock
Power adaptor
Instruction manual
Range of application and all the benefits of your new instrument at a glance:
Inductive charging station (Qi certified) and USB charging function for mobile devices
Colour display with automatic colour change or direct colour selection with two brightness levels
Indication of clock, alarm time and alarm symbol
Alarm with rising alarm tone and 2 volume levels
Snooze function
Non-slip stand with 4 rubber pads
For your safety:
This product is exclusively intended for the range of application described above. This product should only be
used as described within these instructions.
Unauthorized repairs, alterations or changes to the product are prohibited.
Caution! Risk of electrocution!
Plug the device only into a mains socket installed within your country's electrical safety regulations and with a
correct mains voltage (see nameplate).
The mains socket must be located near the equipment and it must be easily accessible.
Unplug the device immediately if any fault occurs.
The device and the power adapter must not come into contact with water or moisture.
Only suitable for indoor use.
Do not use the device if the housing or the power adapter are damaged.
Operate the device out of reach of persons (including children) who cannot fully appreciate the potential risks
of handling electrical equipment.
Only use the supplied power adapter.
Connect the lead to the device first and then plug the power adapter into the socket.
Do not pull the plug out of the socket by its cable.
Route the mains cable so it does not come into contact with sharp-edged or hot objects.
6
English
WARNING
Keep this device and the battery out of reach of children.
Small parts can be swallowed by children (under three years old).
Batteries contain harmful acids and may be hazardous if swallowed. If a battery is swallowed, this can lead
to serious internal burns and death within two hours. If you suspect a battery could have been swallowed or
otherwise caught in the body, seek medical help immediately.
Batteries must not be thrown into a fire, short-circuited, taken apart or recharged. Risk of explosion!
Low batteries should be changed as soon as possible to prevent damage caused by leaking. Make sure the
polarities are correct. Avoid contact with skin, eyes and mucous membranes when handling leaking batteries.
In case of contact, immediately rinse the affected areas with water and consult a doctor.
CAUTION
Unauthorized repairs, alterations or changes to the product are prohibited.
Do not expose the device to extreme temperatures, vibrations or shocks.
Clean the instrument with a soft damp cloth. Do not use solvents or scouring agents.
Protect the device from overheating and provide sufficient ventilation during operation. Make sure that the
device is placed on a solid, clean surface. Do not place the device on cloth, carpet, paper or other objects that
could obstruct the ventilation. Remove dust or other obstacles from the ventilation slots on the bottom
of the device.
Remove in case your metallic phone cover and do not place any metal objects on the charging pad.
Do not place any other objects on the charging pad.
Do not apply excessive force when connecting a USB cable. The USB plug fits only one way into the USB port.
Remove the battery and pull out the plug of the socket if the device will not be used for an extended period
of time.
Elements:
Display (Fig.1)
A - AM/PM in 12-hour format
B - Time
C - Snooze symbol
D - Daylight Saving Time (DST) symbol
E - ERROR symbol
F - Charging symbol
K - Alarm time
L - AM/PM in 12-hour format
M - Alarm symbol
Top (Fig.3)
A - Charging pad
C -  button
D - SNOOZE/DIMMER button
E -  button
Back (Fig.1)
G - DST ON/OFF button
H - Power adaptor jack
J - USB port
Left side (Fig.2)
A - TIME SET / LOCK / ALM SET switch
Right side (Fig.2)
B - ALARM / / switch
Bottom (Fig.3)
B - Battery compartment
7