Reverse The Door Swing (Optional) - Norcold N4000 Série Manuel D'installation Et D'utilisation

- When using an upper side-wall exhaust vent:
- If the depth of the enclosure is 20 3/8 inches or more and is less than 22 3/8 inches [27], install a bent aluminum or galvanized
steel sheet baffle [26] to the rear of the enclosure (See Art02334 and Art02335).
- If the depth of the enclosure (for N4141) is 21 1/16 inches or more and is less than 23 1/16 inches [27], install a bent aluminum
or galvanized steel sheet baffle [26] to the rear of the enclosure (See Art02334 and Art02335).
- Make sure that the bend of the baffle is the full width of the inside of the enclosure.
- Make sure that the bend of the baffle is even with or below the bottom edge of the upper intake vent door frame.
- Make sure that the top edge of the baffle is between 1/4 inch [213] below the condenser and 1 1/2 inches above the
bottom of the condenser and that there is 1/4 inch or less clearance [15] between the rear of the condenser and the baffle.
- For the best cooling
performance, the baffle
should be 1/4 inch
below the bottom of
the condenser.
- If the depth of the enclosure is
more than 22 3/8 inches [27],
install a wood or an aluminum
or galvanized steel sheet solid
box baffle [21] between the
lower intake vent and the upper
exhaust vent (See Art02336).
- If the depth of the enclosure is
more than 23 1/16 inches (For
N4141) [27], install a wood or
an aluminum or galvanized
steel sheet solid box baffle [21]
between the lower intake vent
and the upper exhaust vent
(See Art02336).
- Make sure that the solid
box baffle is the full width of
the inside of the enclosure.
- Make sure that the
horizontal bottom of the
solid box baffle is even with
or above the top edge of
the lower exhaust vent [9].
- Make sure that distance from the enclosure floor to the vertical bottom edge of the solid box baffle [17] is 10 in. for N4104
and 12 in. for N4150 and 21 in. for N4141.
- Make sure that the back of the solid box baffle is perpendicular to the bottom of the enclosure.
- Make sure that the horizontal top of the solid box baffle is even with or below the bottom edge of the upper exhaust vent
[24].
- Make sure that the vertical top edge of the baffle is between 1/4 inch [213] below the condenser and 1 ½ inches above the
bottom of the condenser.
- Make sure that there is 1/4 inch or less clearance [15] between the rear of the condenser and the baffle.

Reverse the Door Swing (optional)

N4000 series refrigerators are designed so that door swing can be reversed in the field, using kits that can be
NOTICE
purchased separately. Door swing reversal should be done before installing the refrigerator in the vehicle.
13
14
21
10
9
27
11
24
25
17
Installation and Owner's Manual 23
15
213
Art02336