Desoutter Industrial Tools ELB2.5-1250-P Mode D'emploi page 6

Masquer les pouces Voir aussi pour Industrial Tools ELB2.5-1250-P:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 12
Safety Information
well below the applicable threshold limit. Please consider lo-
cal requirements on the disposal of lead at product end of
life.
Regional Requirements
WARNING
This product can expose you to chemicals including
lead, which is known to the State of California to cause
cancer and birth defects or other reproductive harm. For
more information go to
https://www.p65warnings.ca.gov/
EU SAR value
EU SAR value = 1.1
RF Exposure Statement
This transmitter has been tested and found to comply with
FCC General Population RF Radiation Exposure limits set
forth for an uncontrolled environment and meets the FCC ra-
dio frequency (RF) Exposure Guidelines.
Radio Equipment Directive (RED)
The product may be operated in the following countries:
The abbreviations of the member States concerned are: Aus-
tria (AT), Belgium (BE), Bulgaria (BG), Switzerland (CH),
Cyprus (CY), Czech Republic (CZ), Germany (DE), Den-
mark (DK), Estonia (EE), Greece (EL), Spain (ES), Fin-
land(FI), France (FR), Croatia (HR), Hungary (HU), Ireland
(IE), Italy (IT), Iceland (IS), Liechtenstein (LI), Lithuania
(LT), Luxembourg (LU), Latvia (LV), Malta (MT), Nether-
lands(NL), Norway (NO), Poland (PL), Portugal (PT), Ro-
mania(RO), Sweden (SE), Slovenia (SI), Slovakia (SK), Tur-
key(TR) and the United Kingdom (UK).
5150 ÷ 5350 MHz allowed for indoor use only.
FCC compliance Class B
This device complies with Part 15 of the FCC Rules. Any
changes or modifications not expressly approved by the man-
ufacturer could void the user's authority to operate this de-
vice.
Operation is subject to the following two conditions:(1) this
device may not cause harmful interference, and (2) this de-
vice must accept any interference received, including inter-
ference that may cause undesired operation.
FCC Responsible party:
Name: Mark Johnson
Position: General Manager
Address: Chicago Pneumatic Tool Company
LLC 1815 Clubhouse Road Rock Hill
SC 29730
USA
Mobile: +1 800 624 4735
Email: mark.johnson@desouttertools.com
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interfer-
ence in a residential installation. This equipment gener-
ates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instruc-
tions, may cause harmful interference to radio communi-
cations. However, there is no guarantee that interference
will not occur in a particular installation. If this equip-
ment does cause harmful interference to radio or televi-
sion reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:
▪ Reorient or relocate the receiving antenna.
▪ Increase the separation between the equipment and re-
ceiver.
▪ Connect the equipment into an outlet on a circuit dif-
ferent from that to which the receiver is connected.
▪ Consult the dealer or an experienced radio/TV techni-
cian for help.
The device is only in compliance if no changes or modifica-
tions is made to the device. The antenna is fixed to the device
and no change in antenna or fixation of the antenna is accept-
able and such modification is considered to violate the Com-
pliance Statement.
IC compliance Class B
CAN ICES-3(B)/NMB-3(B)
(English) This device complies with Innovation, Science and
Economic Development Canada's licence-exempt RSSs. Op-
eration is subject to the following two conditions:
1) This device may not cause interference; and
2) This device must accept any interference, including inter-
ference that may cause undesired operation of the device.
(French) Le présent appareil est conforme aux CNR d'Inno-
vation, Sciences et Développement économique Canada ap-
plicables aux appareils radio exempts de licence. L'exploita-
tion est autorisée aux deux conditions suivantes:
1) l'appareil ne doit pas produire de brouillage;
2) l'appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d'en compromet-
tre le fonctionnement.
(English) This equipment complies with RSS102's radiation
exposure limits set forth for an uncontrolled environment un-
der the following conditions:
1) This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
6 / 208
04/2022

Publicité

Table des Matières
loading

Table des Matières