Fulgor Milano FTIHD 960 TC X Instructions Pour L'installation Et L'utilisation page 17

*Filtering model
Place the upper plate (Fig. 4.1) on the ceiling. Drill
4 holes, 8 mm each, just next to the slots. Insert
the plastic dowels into the holes (Fig. 4.1-A). Fix
the baffle (Fig. 4.2) to the upper bracket (Fig. 4.3)
with the four self-tapping screws provided (Fig.
4.3 A). Screw up the plate together with the baffle
(Fig. 4.1 B). Then fasten the lower structure (Fig.
6.2) on the hood by making its holes and the me-
tric-thread screws welded on the fan support coin-
cide (Fig. 6.1). Insert the washers and nuts pro-
vided (Fig. 6.2-A) and screw with an appropriate
tool. Connect the drainpipe to the power unit noz-
zle and fix securely with a hose clamp. Insert the
upper structure (Fig. 6.3) into the lowest one and
adjust its height as required by matching it with
the cooking top's minimum height. Tighten the two
structures securely with the screws provided (Fig.
6.3-B). Insert the two extension tubes (Fig. 6.4 &
Fig. 7.5) from above the two structures by making
them come down to the appropriate hood seat.
Lift the hood together with the structure and the
extension tubes to make the four springs (Fig. 6.6-
E) hook to the slots (Fig. 6.3-C). Then tighten the
two elements securely (Fig. 5.1 & Fig. 5.2) with the
safety screws (Fig. 5.2-A) and connect the hood
tube to the baffle's lower hole.
Make the electrical connections. (For versions
with display only) Lift the lower pipe until the cable
strap coming out of the sucking unit is uncovered
and connect it to the display cable strap. Put down
the lower pipe while paying attention it is being
properly introduced into the hood. Lift the upper
tube (Fig. 6.5) up to the ceiling and insert the two
self-tapping screws (Fig. 6.5-D).
Warning!
Before connecting the flexible exhausting pipe to
the motor, make sure the stop valve, which is on
the air outlet of the motor, can swing.
WORKING
FTIHD 960 TC X - FTIHD 1260 TC X (Fig. 8)
A: Light switch on/off
B: Motor switch on/off (1st rate level)
C: 2nd rate level switch
D: 3rd rate level switch
E: 4th rate level switch
F: 10 - minutes timer
Mod. SIL TC - Touch Control version (Dis. 9)
A: Light switch On/Off
B: Reduce speed
C: Luminous telltale
D: Incrase speed
E: 10 - minute timer
The products are endowed with an electronic de-
vice which allows the automatic switching off after
4 hours working from the last operation.
17