Warranty And Liability; Safety Instructions - SATA HRS Mode D'emploi

Operating Instructions SATA HRS
EN
1.4. Replacement, accessory and wear-and-tear parts
In principle, only original replacement, accessory and wear-and-tear parts
from SATA are to be used. Accessories that were not delivered by SATA
are not tested and not approved. SATA assumes no liability whatsoever
for damages incurred due to the use of unapproved replacement, acces-
sory and wear-and-tear parts.

1.5. Warranty and liability

The SATA General Conditions of Sale and Delivery and further contractual
agreements, if applicable, as well as the valid legislation at the time apply.
SATA is not liable in case of
■ non-adherence to the operating manual.
■ use of untrained personnel.
■ unintended use of the product.
■ personal protection gear not being used.
■ original accessory and spare parts not being used.
■ independent conversions or technical changes.
■ Natural wear and tear.
■ abnormal impact.
■ impermissible assembly and disassembly work.

2. Safety Instructions

Read and comply with all directions listed in the following. Non-compli-
ance or incorrect compliance can lead to malfunctions or severe injuries
and even death.
2.1. Requirements regarding personnel
The pressurized cup spray gun may only be used by experienced skilled
workers and instructed persons who have thoroughly read and under-
stood these operating instructions. Do not use the pressurized cup spray
gun when tired or under the influence of drugs, alcohol or medication.
2.2. Personal Protection Equipment
Always use approved breathing and eye protection, hearing protection
and protective gloves, workwear and safety boots when using the pres-
surized cup spray gun and during cleaning and maintenance work.
2.3. Use In Explosive Areas
The pressurized cup spray gun is approved for use/storage in explosive
atmospheres of ex-zone 1 and 2. The product labelling must be adhered
to.
26