Assembly Instructions; Operating Instructions - EWT OSCILLOR Manuel D'utilisation

ASSEMBLY INSTRUCTIONS

1. Lift the stand upright. Assemble the motor with the stand (11) by fastening the stand
screw (12).
2. Unscrew the rear guard securing nut (4) from the motor shaft (6) by turning the nut
anti-clockwise.
3. Mount the rear guard (5) to the motor unit (7) as aligned with three positioning pins
on the front motor. Secure the rear guard with securing nut (4) by turning it into
clockwise position.
4. Assemble the fan blade (3) to the motor shaft (6). and tighten the blade cap (2)
(Important: Make sure the blade cap (2) is tightened on the surface of the motor shaft
(6) ).
5. Attach the front guard (1) to the rear guard (5) and tighten to lock with clip (15) and
fixing screw (14).

OPERATING INSTRUCTIONS

1. Connect the plug into a power supply socket and switch on the power.
2. Switch the fan on by rotating the speed control switch (8) at the rear in clockwise
direction. The switch is also used to adjust the fan speed from
HIGH"3"-MEDIUM"2"-LOW"1" in sequence.
3. The airflow direction can be adjusted upward/downward by simply lift up or down
the motor unit or rear guard. Be careful not to insert your fingers through the
guard.
4. Turn the switch in anti-clockwise to turn the fan OFF.
Speed
Turn speed control switch (8) repeatedly to adjust the fan speed from HIGH"3"- MEDIUM
"2"- LOW "1" in sequence. Turn the switch in anti-clockwise to stop operates.
Oscillation
To activate the oscillation, push down the oscillation knob (9).Pull up the oscillation knob (9)
to stop the oscillation at the desired direction of airflow.
OSCILLOR
21 | P a g e