Assembly Instructions - EWT Turnado 360 Manuel D'utilisation

ASSEMBLY INSTRUCTIONS

1 Grill closing latch
2 Grill belt
3 Front centre grill
4 Front grill
5 Fan blade lock nut
6 Fan blade
7 Rear blade lock nut
8 Rear grill
9-10-11 Motor assembly
12 Horizontal oscillating head
13 360° oscillating head
14 Upper part
15 Clamping screw
16 Support tube
17 Round base plate
18 Front panel
19 LCD screen
20 Infrared sensor
21 Button control
28
1. Pass the L-shaped screw through the hole in the base plate (17), place the support
tube (16) on the base plate and screw it tight.
2. Place the base plate connected to the support tube (16) on a bench or a flat
surface, check that the parts to join, located on the support tube, are in line with
the holes, and then screw on the upper part of the fan tightly.
3. Assemble the rear grill on the motor axle and secure tightly using the locking nut (7).
4. Assemble the fan blade on the motor axle and secure tightly using the locking nut
(5).
5. Assemble the front grill (4) on the rear grill (8), including all the assembly clicks
(notches on the inside of the grill belt (2). Close the grill closing latch on the side of
the grill (1), and secure with the screw. Before switching on the appliance, make
sure the grill is firmly secured.
29