Eurosystems P130 Mode D'emploi page 103

Problem Possible causes
The adjustment of the two
transmission arms was done
incorrectly or backlash was
THE SPEED
created during operation.
OF THE TWO
WHEELS ARE
The air was not bled when the
DIFFERENT
lubricating oil in one or both of
the gear boxes was topped up
Transmission belt broken
NO TRANSMIS-
SION ON
WHEELS
Dead man's lever cable broken
or adjusted badly
THE HANDLE-
Breakage of the fixing pin
BAR NO LON-
GER HOOKS
INTO ONE
OF THE SIDE
Seizing up of the fixing pin
ANCHORAGE
HOLES
THE MOVE-
MENTO OF THE
ADVANCING The pin is not greased properly
LEVER DOES
NOT FLOW
WHEN THE
DEAD MAN'S
LEVER [24] IS
The clutch lever is not greased
RELEASED THE
CLUTCH LEVER
[22] IS NOT
RELEASED
AD - Authorized Eurosystems Dealer;
U - User
EN-42
Wheels
Lift the machine of the ground
and regulate the length of the
or replaced.
Replace the belt and check
the integrity of the components
Handlebar and handlebar support
Substitute side handlebar
Dismantle the handlebar support
and check the conditions of the
fixing pin Substitute it in the case
of damage and/or grease the
sufficiently
Remedy
transmission arms.
Bleed the air
inside the frame
Replace or adjust the
transmission cable
adjustment cable
coupling
Grease the pin
Grease the clutch lever
Who Reference
AD -
AD -
AD -
AD -
AD -
AD -
User's manual chapter
U "Greasing the forward
gear pin"
User's manual chapter
U
"PTO greasing"