Slope Function - LaserLiner Quadrum Mode D'emploi

Slope function up to 5° – horizontal
This function deactivates the automatic sensor. To use the function, press the
auto/man button. The plus/minus buttons are used to re-adjust the slope by
means of a motor. In the process the X-and Y-axis can be adjust separately.
Refer to the illustrations below.
Slope function up to 5° – vertical
!
When the 5° maximum slope range has been reached, the laser will
stay fixed and blink. In this case, reduce the slope angle.
Slope function > 5°
Steeper slopes can be set using the angle plate,
which is available as an optional extra (product
ref. 080.75). TIP: Allow the device to align itself
automatically and set the angle plate to the zero
position. Then press the auto/man button to switch
the automatic sensor off. Finally, incline the device
to the angle you require.
!
auto/man function LED ON: Manual alignment
Quadrum / Quadrum Green
man
man
± 5°
X
Y X
man
Y
21
GB