LaserLiner Quadrum Mode D'emploi page 22

Laser modes
Rotary mode
The following speeds can be set using the rotary
button: 0, 60, 120, 300, 600 rpm
Spot mode
You access spot mode by pressing the rotary
button repeatedly until the laser stops rotating.
The laser can then be positioned exactly at the
measuring point by means of the direction
buttons.
Scan mode
The scan button can be used to activate and set
a lightintensive segment in 4 different widths.
You position the segment via the direction
buttons.
Hand receiver mode
Working with the laser receiver (available as an
optional extra): Set the rotary laser to maximum
speed and switch on the laser receiver. Refer to
the operating instructions for the respective laser
receiver about this.
Working with the reference/plumb laser
The unit has two reference lasers. In horizontal
operation these lasers can be used to drop a per-
pendicular. In vertical operation these reference
lasers are used to align the unit. This is done by
adjusting the reference lasers parallel to the wall.
This aligns the vertical laser plane at a right angle
to the wall, see illustration.
22
GB