Zoom Function - LaserLiner ActiveFinder XP Mode D'emploi

3
Localising electrical voltages
Position the detector tip in the
area to be tested (e.g. cable,
socket etc.).
!
For safety, check all three phase conductors (L1, L2, L3) for
the presence of voltage!
!
If the acoustic signal is weak or the battery lamp is not as
bright as it should be, replace the batteries.
4

ZOOM function

Press the ZOOM button to increase
the sensitivity of the device (12 V
AC to 1000 V AC). This enables
voltage fields to be located at
significant distance by moving the
device over the area to be tested.
Please be aware that even if a visual signal is not displayed,
voltage may still be present. Differences in the design of the
!
connection socket or the nature of the insulation (thickness
and type) can affect functionality. Voltage cannot be detected
behind panels and metal covers.
5 Battery lamp
Press button 5 to switch the flashlight on and off.
10
EN
When voltage is present, the
detector tip lights red and a rapid
signal sounds.
The detector tip lights orange
when the ZOOM button is
pressed.
When voltage is present, the
detector tip lights red and a signal
sounds at 1-second intervals.