Operation; Before Startup; Dry Vacuum Cleaning - Kärcher WD 3.150 Mode D'emploi

Suction hose with handle
 Slide the suction hose into the connec-
tion, it will lock into place.
(see description / illustration
In order to disconnect it, push down
with your thumb and pull the suction
hose out.
Suction tubes 2 x 0.5 m
 Connect both suction pipes and con-
nect them to the suction hose.
(see description / illustration
Crevice nozzle
 For edges, joints, heaters and hard to
reach locations.
Floor nozzle with hard surface
insert
 Hard floor surface, wet and dry vacu-
uming: Insert the hard surface inlay
into the floor nozzle. The bristles should
point towards the front.
 Carpets, wet and dry vacuuming:
Work without an insert.
(see description / illustration
22
English
Always work with an inserted car-
tridge filter - during wet as well as
)

dry vacuum cleaning!

 Illustration
Mount loose parts delivered with appli-
ance prior to start-up.
 Illustration
Recommendation: To vacuum fine
)
dust, use the filter bag.
 Illustration
Connect accessories.
 Illustration
Plug in the main plug.
 Illustration
Turn on the machine.
Work only with a dry cartridge filter!
 Recommendation: To vacuum fine
dust, use the filter bag.
)
(see description / illustration
 The filling level of the filter bag depends
on the dirt that is sucked in.
The filter bag needs to be replaced
more frequently while sucking in fine
dust, sand, etc.
Clogged filter bags can burst - therefore
make sure to replace the filter bag in a
timely manner!
 Caution: Always use a pre-separator
while vacuuming ashes and soot (order
no. 2.863-139).

Operation

Before Startup

Start up
Dry vacuum cleaning
)