Wet Vacuum Operation; Dry Vacuum Operation; Emptying And Cleaning Tank - Kärcher Wet Dry Vacuum NT68/1 Mode D'emploi

Operations

Wet Vacuum Operation

1. Make sure foam filter is installed on float cage.
2. Plug power cord from machine into properly grounded wall outlet.
3. Switch machine on.

Dry Vacuum Operation

1. Make sure (optional) cartridge filter is installed on float cage.
2. Plug power cord from machine into properly grounded wall outlet.
3. Switch machine on.
Emptying and Cleaning the Tank
When the tank is full the machine will remain on but will loose suction.
1. Turn off and unplug machine.
2. Place machine near drain.
Note: Always dispose of dirty water in an appropriate drain or receptacle.
3. Lower drain hose and open cap.
Note: Water may come out with force. Stand clear of hose outlet.
4. Remove cover and wipe machine down inside and out.
Note: If machine is left for long periods without use, leave cover off or partially open to allow air to
circulate.
16
98013230 WET DRY VACUUM