Wet Vacuuming - Advance SC750 Mode D'emploi

WET SCRUBBING
NOTE: Make sure the Recovery Tank Lid (6) and the Recovery Tank Drain Hose (24) cap are properly seated or the machine will not pick-up water correctly. When
the batteries require recharging the Battery LOW Indicator (F8) will come on (SC750, SC800 models) or the Battery Indicator (E) will fl ash red (Standard models)
and the vacuum motor will shut off after 30 seconds. Transport the machine to a service area and recharge the batteries according to the instructions in the Battery
section of this manual.

WET VACUUMING

Fit the machine with optional attachments for wet vacuuming.
1 Disconnect the Recovery Hose (16) from the Squeegee (12).
2 Attach suitable wet pick-up tools to the hose (Available from Advance).
3 Turn the Master Key Switch (A) ON.
4 Press the Vacuum/Wand Switch (L) (SC750, SC800 models)
or (C) (SC750 ST, SC800 ST models) once to turn ON the vacuum motor.
The vacuum motor will run continuously until the switch
is pressed again to turn it OFF.
NOTE: The "Recovery Tank FULL" indicator is disabled
when the wand mode is activated.
The fl oat will stop the fl ow into the recovery tank.
F7
F8
F1
SERVICE NOTE: Refer to the service manual
for detailed functional descriptions of all
controls and optional programmability.
!
!
F
F5 F6
FORM NO. - 56041820 - SC750, SC800, SC750 ST, SC800 ST - A-19
B
C
D
6
2
24
ENGLISH / A-19
H
G
H1
L
J
4
29
30
14
12
16
I
A