Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
HOPPER POSITION MICROSWITCH OPERATION CHECK
1.
Turn off the machine and remove the hopper (14).
2.
Try to start the machine by turning the ignition key (2) to "I". The machine should not start. Turn the ignition key (2) to "0".
3.
Reinstall the hopper (14).
4.
If the machine keeps operating when the hopper (14) has been removed, contact an authorised Service Center or Retailer
immediately.
FUSE CHECK/REPLACEMENT/RESET
1.
Drive the machine on a level floor. Make sure that the machine cannot move independently.
2.
Turn the ignition key (2) to "0".
Fuse Check
3.
Check one of the following fuses for deactivation:
(32): Main motor fuse FA (70 A).
(33): Right side broom motor fuse FB (5 A)
(34): Left side broom motor fuse FC (5 A) (optional)
Reset any deactivated fuse, when the component that caused deactivation has fully cooled down.
Fuse check/replacement
4.
Disengage the front latch (22) and open the battery and main motor hood (21).
5.
Disconnect the battery connector (36).
6.
Check/replace the relevant fuse among the following:
(29): Battery fuse F0 (125 A).
Check/replace the battery charger fuse (31) as follows:
7.
Open the rear grid (51) by loosening the mounting screws.
8.
Open the fuse holder and check/replace the F2 fuse (30 A).
Reassembly
9.
Connect the battery connector (36).
10. Close the battery and main motor hood (21) and engage the front latch (22).
11. Close the rear grid (51) and tighten the screw.
BATTERY ELECTROLYTE LEVEL CHECK (FOR WET BATTERIES ONLY)
1.
Disengage the front latch (22) and open the battery and main motor hood (21).
2.
Check the level of electrolyte inside the batteries (35). If necessary, top up through the caps.
3.
Close all the battery caps (35).
4.
Close the battery and main motor hood (21) and engage the front latch (22).
5.
If necessary, charge the batteries as shown in the relevant paragraph.
20
INSTRUCTIONS FOR USE
SW900 - 1465374000
Publicité
Chapitres
Table des Matières
Dépannage
