Advance SC750 Mode D'emploi page 13

INSTALLING THE PADS (REV SYSTEM)
CAUTION!
Turn the key switch off (O) and remove the key, before changing the pads, and before opening any access panels.
1 Make sure the Scrub Deck (8b) is in the RAISED position. Make sure the Key Switch (A) is off (O).
2 See Figure 4. If using the Microfi ber Pad (DD), install directly to the Pad Driver Assembly (EE).
3 If using the Maroon Pad (FF), install the standard Red Pad (GG) to the Pad Driver Assembly (EE) fi rst and use the 2 Sided Velcro (HH)
between the red pad and maroon pad to hold it in place.
NOTE: If the Maroon SPP pad is not installed as defi ned above, damage to the pad driver will result!
FIGURE 4
FORM NO. - 56041820 - SC750, SC800, SC750 ST, SC800 ST - A-13
ENGLISH / A-13