Procedure In Case Of Alarm Or Fault - Detnov CCD-108 Manuel D'installation Et Mode D'emploi

Actions in case of out of service:
The only action you can take in this case is to:
• Press the buzzer silence key to stop the acoustic warning.
• Restore the mains power supply (220V).
• Replace the batteries with fully charged ones.
6.4.7- System fault mode
System fault mode is caused when a critical situation occurs in the panel and it cannot
function correctly. The system fault warning is the following:
• General fault warning activated continuously.
• Out of service warning activated continuously.
• Acoustic warning activated continuously.
• Fault output activated.

6.5- Procedure in case of alarm or fault

The panel is designed to ensure an effective response in case of alarm. It is necessary
to know the panel to act correctly in a critical situation.
IMPORTANT: You must read the following steps, as it will help in case of alarm:
1. The main thing when there is an alarm is to remain calm, the panel's fire bells and
sounders that warn of the fire may provoke a state of nerves that prevents us from
reacting and operate correctly.
2. The authorised user should have the key to access to the panel's keyboard control.
3. The authorised user must press the silence buzzer key to silence the panel's
internal buzzer, and if you want to stop the sounders you must press the silence
sounders control.
4. The officer may identify the alarm as the warning lights on the keyboard indicate the
type of alarm or fault that has occurred in the system.
5. Having identified the cause of the alarm it is time to action the current emergency
plan in each site.
6. Once the problem has been solved, the panel has to be reset.
25
GB