Detnov CCD-108 Manuel D'installation Et Mode D'emploi page 54

6.1.3- General Test (3)
This yellow LED indicates that some of the zones are in test mode, It does so by
blinking together with the yellow LED of the corresponding zone.
6.1.4- Enable Sounders (4)
Yellow indicator associated with the sounders:
• Blinking: The sounders will be activated after the programmed delay has passed.
GB
Fixed: The sirens have been activated.
•
6.1.5- Silence Sounders (5)
Yellow led that is activated to indicate that the button has been pressed to silence the
sounders after they have been activated.
6.1.6- Silence Buzzer (6)
Yellow LED is activated when the internal buzzer has been stopped after pressing the
buzzer silencer button.
6.1.7- System fault LED (7)
This yellow LED is permanently active when there is any critical situation in the system.
In this case the system is not operational
6.1.8- Power supply fault LED (8)
This yellow indicator flashes if there is any problem in the power supply, caused by the
mains supply, batteries or fuses.
6.1.9- Out of service LED (9)
This yellow indicator is activated when the panel is not receiving the correct voltage to
operate. There is no mains supply and the voltage supplied by batteries is not enough
for the proper functioning of equipment.
18