Detnov CCD-108 Manuel D'installation Et Mode D'emploi page 55

6.1.10- Sounders delayed LED (10)
This yellow LED indicates that the sounder outputs are time delayed. When there is
an alarm the sounder outputs will not be activated until pass the delay time configured
by jumper.
6.1.11- Fault / Disablement Sounder LED (11)
Yellow indicator associated with the outputs of sounders:
Blinking: There is a sounder fault.
•
• Fixed: The sounders are disabled
6.1.12- Power LED (12)
This green indicator indicates that the unit is powered either by mains or by batteries.
6.1.13- Alarm LED (13)
This red indicator is activated when the panel detects an alarm:
• Blinking: There is an area that has gone into alarm status caused by a detector. In
this case there is no alarm caused by the activation of a manual button.
Fixed: There is an area that has gone into alarm status caused by a manual button.
•
The manual buttons take priority over the detectors.
6.1.14- Disablement LED (14)
This yellow LED indicates that a zone or the sounders in the installation are disabled.
If it is a zone, the yellow LED of the corresponding zone will also illuminate.
If it is the sounders, the sounders fault / disablement LED will also illuminate.
6.1.15- Fault LED (15)
This yellow LED is blinks when the panel detects any kind of fault in any of its elements.
To know where the fault has come from, you must look at the individual warning LED.
19
GB