Electrical Wiring - Detnov CCD-108 Manuel D'installation Et Mode D'emploi

3.3.5- Electrical wiring

It is recommended that the equipment is powered and tested before connecting
devices such as sensors, manual call points etc.
The panel must be connected via an external circuit breaker using a 1.5 mm cable
2
section. The voltage should be 230V.
To avoid crossing the network, the mains cable must be separated from the zones
cables.
GB
If the system can be affected by an electrical disturbance, we recommend the use of a
ferrite tube as close as possible to the connection.
It is imperative to use the holes marked in the box for connecting the power supply
wires and those from the areas to the terminal block. Use a "crown" drill bit to perforate
the box and insert the PG13 type gland.
9