Symbols And Conventions - Algas SDI SECOND SUN Manuel D'utilisation Et D'entretien

SYMBOLS and CONVENTIONS
Special symbols are used to denote hazardous or important information. You should
familiarize yourself with their meaning and take special notice of the indicated information.
Please read the following explanations thoroughly.
GENERAL WARNING or CAUTION
This symbol indicates hazards or unsafe practices, which can result in damage to
the equipment or cause personal injury. Use care and follow the instructions g iven.
FLAMABLE GAS HAZARD
This symbol indicates hazards or unsafe practices, which can result in damage to
the equipment or cause personal injury. Use care and follow the instructions g iven.
Read the OPERATION MANUAL before operating this equipment.
■ NOTE: Algas‐SDI reserves the right to use alternate manufacturers'
■ This equipment uses LPG ‐ a flammable fuel handled under pressure.
Inherent hazards exist, and a thorough understanding of the equipment
is required to allow safe operation and maintenance.
■ Allow only a TRAINED and FULLY QUALIFIED PERSON to service this
equipment.
■ Any time a component must be replaced, use the same type, model, etc.
DO NOT SUBSTITUTE! The consequences from such actions are
unpredictable, will void your warranty and may lead to undesirable
consequences. When components are replaced with components not
approved for use in this ATEX/TUV/ETL/IECEx/CE listed equipment, the
ATEX/TUV/ETL/IECEx/CE listing becomes void for that unit.
4
WARNING
components as vendor delivery applicability dictates. Literature
contained in the Operation Manual has been supplied by
vendors. Please check to be sure supplied data matches your
configuration. Contact Algas‐SDI if any questions exist.
ASDI Operations and Maintenance – Second Sun – P/N 52793