Algas SDI SECOND SUN Manuel D'utilisation Et D'entretien page 17

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

 
 
 
7. Wait  30  minutes  and  check  the  back  of  the  heater  for  increased 
temperature (too warm for continual contact) – 150° F (66° C), depress 
the pilot knob again to ensure it is engaged. 
 
8. Turn  the  gas  valve  to  the  "On"  position  after  30  minutes  or  when 
terminals 3‐5 read 200+ mV. See Figure 14. 
 
9. Wait 10 minutes before disconnecting and storing battery cables. 
    
                                                                                                      
Stopping the Heater 
1. If the heater is on and you wish to manually switch the operation to stand‐by mode, turn the black 
knob on the gas control valve to "Pilot" setting. 
 
2. To shut the heater off completely, close the manual, on‐off ball valve (isolation valve) outside of the 
control cover. The heater can also be turned off by closing the isolation valve on the Propane/LPG 
tank. See Figure 15. 
ASDI Operations and Maintenance – Second Sun – P/N 52793 
 
Fig. 15 
                                                             
Fig. 14      
 
17 

Publicité

Chapitres

Table des Matières
loading

Table des Matières