Maintenance And Cleaning - IKA lab dancer Mode D'emploi

Correct use
The IKA lab dancer is designed for shaking test tubes.
Gently push the test tube into the soft attachment to start
shaking. Shaking stops as soon as you lift out the test tube.
Unpacking
Please unpack the device carefully and check it for damage.
It is important that any transport damage is detected when
the device is unpacked. If necessary, an inventory of the
damage should be made immediately (postal service, railway,
haulage company).
As supplied, the package contains:
The IKA lab dancer, a plug-in power supply unit and an
instruction manual.
Commissioning
Connect the appliance to a socket (Please refer to the infor-
mation in the "Technical Data" section).

Maintenance and cleaning

The IKA lab dancer is maintenance-free. It is subject only
to the natural wear and tear of components and their statis-
tical failure rate. Use only cleansing agents which have been
approved by IKA to clean IKA devices.
To remove use:
Dyes
Constructions materials water containing tenside/
Cosmetics
Foodstuffs
Fuels
For materials which are not listed, please request information
from IKA.
Wear the proper protective gloves during cleaning of the
devices. Electrical devices may not be placed in the cleansing
agent for the purpose of cleaning.
Before using another then the recommended method for
cleaning or decontamination, the user must ascertain with
the manufacturer that this method does not destroy the
instrument.
isopropyl alcohol
isopropyl alcohol
water containing tenside/
isopropyl alcohol
water containing tenside
water containing tenside
7