How To Assemble And Operate The Vacuum - Tennant V-LWU-13 Manuel D'utilisation

HOW TO ASSEMBLE AND OPERATE THE VACUUM

How to Attach the Handle to the Vacuum Cleaner
The vacuum cleaner and the handle are packed separately.
1. Release the handle bracket from the handle tube by removing the two screws. (Fig. 2) Save the screws.
2. Place handle onto the handle tube, aligning holes with pegs. (Fig. 3)
3. Place the handle bracket back into position. (Fig. 4)
4. Secure with two screws removed in step 1.
5. Thread cord through cord guides and proceed with wrapping the cord. (Fig. 5)
6. Wrap the cord clockwise around the top and bottom cord hooks. Fasten the plug to the wrapped cord using
the channel on the plug. When not in use store the appliance indoors in a clean dry area. (Fig. 6)
(Fig. 2)
How to Operate Vacuum Cleaner
The On/Off switch is a three position switch. The middle setting "0" is the off position. (Fig. 7). The top setting
"I" is the on position (Fig. 8) and the bottom setting "II" is the maximum power position (Fig. 9). Use the top
setting "I" for cleaning hard floors and throw rugs.
Always turn switch to off setting "0" before returning the handle to the upright position and before unplugging
cord from electrical outlet.
(Fig.3) (Fig. 4)
(Fig. 7) (Fig.8)
(Fig. 5)
(Fig. 9)
6
(Fig. 6)