Brush Circuit Breaker; Vacuum Motor Thermal Overload; Attachment Tool Operation; Vacuum Bag Removal/Installation - Tennant NOBLES V-WA-26 Manuel Opérateur

BRUSH CIRCUIT BREAKER

Vacuum is equipped with a resettable brush circuit
breaker. Circuit breaker will trip under conditions of
excessive brush overload. Periodically check brush for
entangled carpet strands and debris. If circuit breaker
should trip. Remove obstruction and reset circuit
breaker switch by pushing button located under brush
housing. Resume to normal operation (Figure 5).
FIG. 5
WARNING: Do Not Operate With Damaged
Power Cord. Do Not Modify Plug. Unplug Power
Cord Before Servicing Machine
If the supply cord is damaged or broken, it must be
replaced by the manufacturer or it's service agent
or a similarly qualified person in order to avoid a
hazard.

VACUUM MOTOR THERMAL OVERLOAD

Internal temperature of vacuum motor is sensed at all
times. When temperature gets too high sensor shuts
off vacuum motor. Inspect vacuum for any air
obstruction. Sensor will automatically reset when motor
has cooled. Motor can then be re--started.

ATTACHMENT TOOL OPERATION

Attachment Tool Kit is sold separately. (Attachment
Tool Kit #190048) Includes: Crevice Tool, Dusting
Brush, Upholstery Tool, 1.5m (5 ft) Vacuum Hose and
Extension Wand.
1. Keep vacuum in the upright position at all times
when using attachments.
2. Disconnect vacuum hose from elbow on handle
housing.
V- -WA- -26 / V- -WA- -66 (04- -10)
Brush Circuit
Breaker
Home Find... Go To..
3. Connect attachment tool vacuum hose to elbow
and desired tool to opposite end (Figure 6).
Elbow
Attachment
Tool
FIG. 6
4. Activate ON/OFF switch and operate tool using
normal vacuuming procedures.
WARNING: Do Not Pick Up Flammable Or
Toxic Materials, Burning Or Smoking Debris.

VACUUM BAG REMOVAL/INSTALLATION

WARNING: Do Not Operate With Damaged
Power Cord. Do Not Modify Plug. Unplug Power
Cord Before Servicing Machine
1. Open rear door by turning door latch/upper cord
hook 90_ (Figure 7).
Door Latch
Slide Bag
Collar Off
Intake
Spout
FIG. 7
2. Slide vacuum bag collar off intake spout.
PAPER BAG: Dispose paper bag when full. DO
NOT reuse paper bag.
CLOTH BAG: Unclip end of bag and release
debris into disposal container. Shake out excess
dust and inspect for tears or holes.
3. Directly replace with new or empty cloth bag. Push
bag onto intake spout as far as it will go.
OPERATION
EN
13